1. Surface Must be Clean and wax-free for best results.

2. Make a solution of 1 cup of  pure water and 2-3 drops of Palmolive liquid dish washing detergent. You want a mixture that will cause water to evenly spread over a surface like a film and not like a freshly waxed surface like when your car is freshly waxed. If you have removed ALL wax from the application surface, you can use plain water alone. Apply the solution evenly to the surface to receive the decal.

4.Once you have applied the decal, then starting from the center begin to carefully squeegee the air bubbles to the edges, always using your soft squeegee and/or a thin cloth towel not skipping over any section. Here you can apply slight stretching techniques to conform a flat decal over a curved surface. Just don't stretch more than necessary; excessive stretching will cause durability problems including cracking later as the decal cures. Small bubbles will disperse in sunlight and heat.  Large bubbles may require pinholes to allow the air to escape.